Overwhelmed by the Complexity of Resources? This May Help

What You Need to Know About Misting or Fogging System Installation

A misting system installation is not entirely difficult as long as you have all the needed parts and the basic tools like wrenches and screwdrivers everything will go as planned.

Before installation you must see to it that there were no existing defects found in the parts and all parts are in the parcel. Take a hard look with the manual and the ways by which all parts must be installed, this way you can expect the installation process to be smooth sailing. There are three things that you must consider when it comes to fogging system installation, first is the pumping unit; it should be put together in a proper manner then a good power source and the water of course.

It is also vital that you are able to place the fogging system pumping unit in a place where it will not be susceptible to damage. The power source and the water supply must be near the fogging system unit so that it can operate more so this is another thing that you have to consider for its location.

If you are able to connect the mainline to the fogging unit then you can proceed to the next step in installation. There are some that uses a flex hose and stainless steel for the mainline (this is the line that connects the misting unit to the area by which the nozzle line will be placed) If the nozzle line can only be installed using stainless steel suspension cables, these cables must be placed to both sides of the area that you want to be misted. There is also what you call a turnbuckle that is placed on a one end of the capable so that the tightness can be controlled furthermore in order to avoid uneven positioning of the line; a support cable is installed for every 10 feet.

Proper installation of ball valves on the suspended cables or on the hard surface is also necessary. Afterwards, the installation of misting lines should be done. If you intend to use a misting system that is made from stainless steel then you must utilize a nozzle line that is 20 feet long.

For those that is using 20 feet long lines brass fittings are usually used. It is also common to find rubber “O” rings for misting systems that make use of brass fittings. Water tight system is necessary in such misting systems that is why “O” rings must be placed on both sides. It is not also advisable to use a very tight union for the “O” ring might break down and penetrate the system. It is also vital to install a drain valve at the end of each nozzle line. Those are pretty much an overview of what misting and fogging installation is all about should you wish to know more you can just search for more info online.

5 Uses For Systems

Short Course on Mists – What You Need To Know